BALDOR NEXTMOVE PCI DRIVER

Starting Workbench V5 5. Units And Abbreviations Receiving And Inspection Installing The Nextmove Pci Card Click Apply at the bottom of the screen.

Uploader: Vudozilkree
Date Added: 4 April 2004
File Size: 58.79 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 56200
Price: Free* [*Free Regsitration Required]

Baldor Can Nodes A. Encoder Input Frequency 4.

The safe operation of this equipment depends upon its use in the appropriate environment. Stepper Axis – Testing 5. The NextMove PCI must be installed in an enclosed cabinet located so that it can only be accessed by service personnel using tools.

A Startup block should be included in every Mint program, so that mextmove a program is loaded and run the NextMove PCI will be correctly configured. Nextmove Pci Expansion Card Two module types are available: Stepper Axis – Testing In the following example, digital input 1 will be nextjove to trigger on a falling edge, and allocated to the forward limit input of axis 0: Click in the Scale box and type a value.

Servo Systems Co. | Baldor | NextMove PCI-2

If you do have a problem, read this section first. This document or attached software may not, in whole or in part, be copied or reproduced ppci any form without the prior written consent of BALDOR. Other Information Needed For Installation If the setup wizard does not appear, select Run Servo Axis – Eliminating Steady-state Errors 0. As a guide, Figure 9 shows an example of the typical minimum wiring required to allow the NextMove PCI and a single axis servo amplifier motor drive to work together.

New Drivers  HOW TO INSTALL ATHEROS AR5006X DRIVER

Smith, AR Tel: Only qualified personnel should attempt to start-up, program or troubleshoot this equipment.

Relay Output x8 Most servo amplifiers can be set to current torque control mode or velocity control mode; Alternatively, the information can be included in program files as part of the Startup block. Units And Abbreviations Testing The Drive Enable Output Click OK to continue.

Baldor NEXTMOVE Pci-2 Motion Controller Card 8 Axis Control Opto Isolated I/o

Table of Contents Add to my manuals Add. Maximum cable length Frequency Baldor MicroFlex e Can be configured in this mode and neextmove ideal for axis functions such as guides, indexers, conveyors, tension rollers etc.

Starting Workbench V5 5. If you have followed all the instructions in this manual in sequence, you should have few problems installing the NextMove PCI.

NextMove PCI

Expansion cards are available to take this to 12 axes of servo and 12 axes of stepper. This manual is copyrighted and all rights are reserved.

New Drivers  LEXMARK T630 PRINTER DRIVER DOWNLOAD

The stepper control is an open loop system so no tuning is necessary. Reset can occur due to baldog, a watchdog error or when deliberately caused by the host PC.

This equipment may be connected to other machines that have rotating parts or parts that are controlled by this equipment.